Comments on: HybridTechUSA.com Hybrid Semi Truck HHO Installation HYDROGEN POWERED SEMI

By: Rain4Fuel

Rain4Fuel — Tue, 15 Dec 2009 19:57:48 +0000

you have semi trucks or someone's HHO units on them?

By: djsteve96

djsteve96 — Tue, 15 Dec 2009 19:57:48 +0000

we have 2 trucks like that where a work and they dont have enough power when u drive on a higher street

By: frithwks

frithwks — Tue, 15 Dec 2009 19:57:48 +0000

Sweet looking setup!

I've got to say I'm a little sceptical about the savings of such a device. How do you determine whether this small amount of Hydroxy causes the engine to run rich?

I'm guessing this setup produces roughly 4 to 5 liters of gas per minute at your stated 77 Amps???

By: Rain4Fuel

Rain4Fuel — Tue, 15 Dec 2009 19:57:48 +0000

this is Jeff Sokol's video, not D3's.

By: FLYEXTREME

FLYEXTREME — Tue, 15 Dec 2009 19:57:48 +0000

hi d3, can you tell me anything about requirements to fitting hho generators to larger trucks, do they need additional componants for the o2 etc,???

By: Rain4Fuel

Rain4Fuel — Tue, 15 Dec 2009 19:57:48 +0000

There are several ways to combat the cold with our cells. One way, is to add windshield washer fluid, the below freezing kind, which is mostly water. A better way however, is to install a light which will keep the interior of our cells from becoming cold. Our cells are inside of aluminum boxes, larger than the one you see in this video with much more room inside. Thanks for the question.

By: babaluto

babaluto — Tue, 15 Dec 2009 19:57:48 +0000

So what do we do about freezing when it's 10 degrees??? or dare I say, colder?? I had a good friend lose his multi-plate cell because it froze solid on his rig.

By: Rain4Fuel

Rain4Fuel — Tue, 15 Dec 2009 19:57:48 +0000

Sorry, but this is proprietary information. This information is only available to distributors of HybridTech, however sometimes it isn't necessary.

By: jriggs8012

jriggs8012 — Tue, 15 Dec 2009 19:57:48 +0000

Can you tell me what setting you typically tweak, im just looking for a place to start with my truck, thanks

By: Rain4Fuel

Rain4Fuel — Tue, 15 Dec 2009 19:57:48 +0000

Our team has invested a lot of time and money into creating our packages. Changes do not need to be made to the ECM for good performance, but in order to optimize the use of the HHO we tweak certain parameters in the ECM. This is on a case by case basis, and how much the client wants to invest in his truck.

By: jriggs8012

jriggs8012 — Tue, 15 Dec 2009 19:57:48 +0000

Did you do anything to change the sensor readings on the ecm? Have you seen an increase yet? What year engine? is it an HPCR fuel system?

By: Rain4Fuel

Rain4Fuel — Tue, 15 Dec 2009 19:57:48 +0000

After the turbo, pulling 77 amps.