Comments on: Hydrogen Cutting Steel, HHO Torch AQUAFLAME TECHNOLOGY,

By: 5laces

5laces — Sun, 04 Apr 2010 19:48:52 +0000

how many litres are you getting per minute

By: HyJaxLTD

HyJaxLTD — Sun, 04 Apr 2010 19:48:52 +0000

Its AMZAING what returning to SIMPLICITY brings, eh?

By: Rain4Fuel

Rain4Fuel — Sun, 04 Apr 2010 19:48:52 +0000

This is true! However, we can do the same thing by adding bottled oxygen to the mix, only for slag use. Torches are probably my favorite part of HHO technology…

By: altern8energy

altern8energy — Sun, 04 Apr 2010 19:48:52 +0000

if you use a pressurized tank to build up pressure and use the squeeze valve on the torch to increase gas pressure at the tip I wonder if you could make cutting even faster. the squeeze valve on the torch is used to blow away slag when using oxy-acetylene. I figure I higher volume of HHO gas out the torch tip would do the same if not slice through much thicker plates of steel.

By: harryfodder

harryfodder — Sun, 04 Apr 2010 19:48:52 +0000

yea you can weld steel to brick with HHO

By: harryfodder

harryfodder — Sun, 04 Apr 2010 19:48:52 +0000

stan meyer spoke of adding non combustible gases to reduce the burn rate and heat of the HHO to match other burning gases… i suppose that green hose could be used to supply CO2 or some other non combustible gas for different projects where not as much heat was required

By: Rain4Fuel

Rain4Fuel — Sun, 04 Apr 2010 19:48:52 +0000

Yes sir, it is HHO, 100% (well maybe a little steam). We used the hoses that came with the torch set up. The red one is hooked to a grey one, that's hooked to my truck. The green hose is not hooked to anything, but could be used for additional oxygen.

By: HHOinfo

HHOinfo — Sun, 04 Apr 2010 19:48:52 +0000

That is Not HHO. it is oxyacetylene. Note the two hoses going into the torch at 25 seconds. One red & one green.

By: daniel2008C

daniel2008C — Sun, 04 Apr 2010 19:48:52 +0000

Well, I posted several videos about , but still none using Oxygen ..I guess will do it soon, you are right a video proof is required … .

By: qwertrewq9879878712

qwertrewq9879878712 — Sun, 04 Apr 2010 19:48:52 +0000

Ok, then why isn`t so popular as oxi-fuel welding? I mean did you prove that equipment welding,not soldering or brazing,the steel pipe of the example stated before? Can you post any videos?thanks

By: daniel2008C

daniel2008C — Sun, 04 Apr 2010 19:48:52 +0000

HI ; You need to add Oxygen to weld steel , but you may can forget acetylene for ever with HHO , AND will use 1/2 the Oxygen for the same job , a win -win situation

By: qwertrewq9879878712

qwertrewq9879878712 — Sun, 04 Apr 2010 19:48:52 +0000

can i use this great technology as substitute to oxyacetylene welding for example a simple motorbike trailer 2mm steel square pipe ?
thanks