New Clam Shell Design/Concept of our Lowes store bought plates made into a HHO-Cell. Tap water with Baking Soda as electrolyte. This is in pre-stages before we fit to the case a recycle take-up tube to go back into the hho-cell for re-up-take of the gas produced on a prior cycle. Experimenting to see how it works from concept to design. Thanks for viewing my videos.. Regards, --HOAX

More on Hydrogen Cell HHO "Clam Shell Design" Intensifying the gas 1

Tags: digital efie, water fuel system, ebay hho, install hho generator

Check www.BurnWaterAsFuel.bravehost.com for Details Car That Runs Off Water Car That Runs On Water Car That Runs On Water Energy Car That Operates On Water Car That Runs On Water Fox news Car That Runs On Water Thailand Car That Runs With Water Car That Will Save On Gas Car Using...

More on Hydrogen Fuel Cell Kits and Instructions – How To Convert A CAR To Use WATER As Fuel – Cars Running On H20 Run with H2o Hydrogen Fuel Cell – Alternate Car Energy Sources Fuel MPG Gas Mileage Saver Device Saving

Tags: ebay hho, digital efie, hho bubbler, hho system

Here is the enclosure being made to be permanently installed in my 1998 Nissan Altima 2.4Liter Engine Compartment. Took me a couple of hours to throw the parts together, just wanted to make sure everything was in tight so there was no room for vibration loosening things up. Please take note of the placement of the HHO-Cell, right above the exhaust header. That is why if you also notice, we installed a galvanized heat shield right below the enclosure. Just to make sure this doesn't become an issue when we try to calibrate our heat inside the hydrogen cell. Regards, and Thanks for viewing my video.. --sirhoax

More on Hydrogen Fuel Cell HHO – Car Enclosure Install Nissan Altima

Tags: hho conversion guide, digital efie, water for gas system, hho generator plans

This is a clam shell design we put together with a tighter spacing inside between the two outer plates and the one smaller inside plate. Initial test was just to see how boiled water reacts with our HHO-Cell design. This has to be one of the smallest cell configurations found, and it is putting out a huge amount of vapor for its size. Will do more tests, volume output (liter per minute), and ignition of the gas coming off the top of the water. To prove legitimacy of the design and concept at ...

More on Hydrogen HHO Fuel Cell – "Clam Shell Design" Boiling Water

Tags: install hho generator, digital efie, hho gas generator, hho system

Here is the enclosure being made to be permanently installed in my 1998 Nissan Altima 2.4Liter Engine Compartment.

Took me a couple of hours to throw the parts together, just wanted to make sure everything was in tight so there was no room for vibration loosening things up.

More on Hydrogen Fuel Cell HHO – Car Enclosure Install Nissan Altima

Tags: hho installation guide, hho gas generator, digital efie, install hho generator

This is our homemade shunt for running higher amperage tests in combination with our hho-cell. Everything here can be store bought at Home-Depot, Lowes, or just about any hardware store.

More on Hydrogen Fuel HHO Cell High Amperage Testing Method (Shunt)

Tags: digital efie, hho system, hho gas generator, hho generator blueprint

This is a clam shell design we put together with a tighter spacing inside between the two outer plates and the one smaller inside plate. Initial test was just to see how boiled water reacts with our HHO-Cell design.

More on Hydrogen HHO Fuel Cell – "Clam Shell Design" Boiling Water

Tags: install hho generator, water fuel system, hho gas, digital efie